IEEE Club Design Applications

These applications are CGI programs (written in C) that perform calculations on input values supplied by the user. All applications represent typical circuits or techniques found in our courses.

Regulated Power Supply Determine component values for an opamp-based regulated power supply, based on desired output voltage and current. Try 5 volts, 0.1 Amps.

Low Pass Filter Determine the corner frequency and gain response of a passive, RC-based low-pass filter. Try R = 4700 ohms, C = 0.01 uF, and F = 1000 Hz.

Decimal to Binary Converter Convert a decimal input number to binary. Try 1000 decimal.

Last modified by Chris Hull, ET99, on November 30, 1998 [Main Page]

Regulated Power Supply	Determine component values for an opamp-based regulated power supply, based on desired output voltage and current. Try 5 volts, 0.1 Amps.
Low Pass Filter	Determine the corner frequency and gain response of a passive, RC-based low-pass filter. Try R = 4700 ohms, C = 0.01 uF, and F = 1000 Hz.
Decimal to Binary Converter	Convert a decimal input number to binary. Try 1000 decimal.